##Introduction## To get the cameras to trigger simultaneously, we chose to trigger them via USB using a feature of the CHDK. Dual camera 555 trigger ##Assembling the 555 circuit## * Pretty good instructions come in the 555 timer package * Potentiometer confusion * Stripping and attaching the USB cables Dual camera 555 trigger ---- ##Connecting the batteries## ###Battery selection### * Two different batteries are needed: * a 12 volt battery to run the timer, and * a 5.5 volt (or more) for actually triggering the camera. **12v battery issue** For the 12 volt battery there are a few options, but **since the 12v battery which shipped with the kit seems to be inadequate**, we are now recommending two 9v batteries connected in series to make an 18v battery, shown below. This is a bit too much power but it seems to run fine. There are other, lighter weight alternatives, [such as described by Chris Fastie](http://publiclaboratory.org/notes/cfastie/5-2-2012/no-output-signal-ir-kit-timer#comment-719).
5 coin cell batteries + 1 screw fit in the holder Place them inside one by one
To keep things simple, and because it's hard to find an efficient, cheap and lightweight way to hold 4 cell batteries, here we show how to fit 4 coin cell batteries into an N-type battery holder, which is provided in the dual infrared kit -- using a small wood screw. This is a bit of a "hack" but has worked very well - 4 1.5 volt batteries is ~6v and very little current is needed to actually trigger the camera. Four should fit snugly and securely ###Attaching to the 555 timer (extra wire)### (coming soon) ---- ##Splicing USB cables##
Snip the USB cable to at least 8 inches long
Using a wire stripper, cut at least 8 inches of USB cable, preserving the smaller connector. Strip off the plastic wrapping to expose the smaller wires within and trim away the foil, fine metal strands, and the green and white wires. You'll want more extra wire than shown - maybe trimming to leave an inch of exposed red and black wires will give you some working room. Do this for 2 USB cables, identically. Now, you can take both red wires and the red wire from one of your (N-type) battery holders, twirl them together, and solder them together firmly. Do the same with JUST the two black leads from the USB cables.
Separate out the wires from the wrapping Snip off all but red and black; strip off their wrapping
You should be left with two loose black leads: one a combined lead from the USB cables and one from the other end of your battery holder. Place them into the headers of the 555 timer as shown and screw them into place (the screws will hold the wires firmly in the headers. 555 dual camera triggering wiring Here are a couple images of the whole setup: 555 timer diagram 555 dual camera triggering setup